company news about Daxian：How to deal with problems with the tensile machine software?

When we encounter a lot of problems during the operation of the tensile machine, how to solve it when there is a problem with the software of the tensile machine? Let's take a look at it

1. When using the tensile machine software on the computer, click to start the test and always pop up the prompt "online failed", in this case, the description is: the software fails to connect with the machine successfully, check whether the serial port cable is connected to the computer, whether the machine is powered on, in order to ensure that the connection is not when the tensile machine software is used on the computer, click the menu "settings" and "online", select the connected COM port for online, if you don't know the connected COM port, you can select the COM port one by one for online until the connection is successful. If you still can't connect to the machine successfully, quit the software, turn off the power of the machine, and then restart the machine and the software attempt.

2. When using the tensile machine software on the computer, the interface always pops up after a period of time, "the service life has expired, please contact the manufacturer", and when you encounter this problem, please contact the manufacturer, get the registration code, and re-register the software to use it normally.

3. When using the tensile machine software on the computer, if you encounter: click "up" or "down", the running speed of the machine does not match the set speed, but it always runs fast, please remove the "√" before the "user parameter setting" - > "control scheme" - > "control parameters" - > "speed closed-loop control", if there is no displacement encoder or the displacement has not been calibrated, please do not turn on the "speed closed-loop control".

4. When using the tensile machine software on the computer, if you encounter: after clicking the "test" button, the machine has just run for a while, and the sample has just been stopped by force, please set the value of "user parameter setting" - > "control scheme" - > "test method" > "starting judgment ratio" to be larger, and do not judge the fracture when it is lower than this value, so that it will not stop due to misjudgment of fracture at the beginning of the test.

5. When using the tensile machine software, the machine cannot automatically return to the position without connecting the encoder. Because if there is no encoder, the machine has no stroke value, and the machine return is to detect the stroke value to achieve the return to the zero point of the stroke, so there is no stroke value can not be returned, and the encoder must be connected to the return function.

6. When using the tensile machine software on the computer, if you encounter: when you click "up" or "down", the running direction of the machine is not consistent with the setting, and the direction is reversed, please put "√" in front of "Setting"-> "Calibration"-> "System Settings" in "Reverse Rising and Falling Direction", and then click the button "Write calibration data to the acquisition card".

7. When using the tensile machine software on the computer, if you encounter the situation that the running direction of the machine is inconsistent with the setting when selecting "tensile" or "compression" in the test method, and the direction is reversed, please mark "√" in front of "Setting" - > "Calibration" >- "System Settings" in "Reverse Tension and Compression Direction", and then click the button "Write calibration data to the acquisition card".